Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

11.3 List of ParametersParameterNo.Name Setting Range Unit FactorySettingSettingValidationPn50E Output Signal Selections 1 − − 3211 AfterrestartReferenceSection−n.4th 3rddigit digit 2nddigit1stdigitPositioning Completion Signal Mapping (/COIN)(Refer to "8.6.5 Positioning Completed Output Signal.")0 Disabled (the above signal is not used.)1 Outputs the signal from CN1-25, 26 output terminal.2 Outputs the signal from CN1-27, 28 output terminal.3 Outputs the signal from CN1-29, 30 output terminal.Speed Coincidence Detection Signal Mapping (/V-CMP)(Refer to "8.5.8 Speed Coincidence Output.")0 to 3Same as /COINRotation Detection Signal Mapping (/TGON)(Refer to "8.11.3 Running Output Signal (/TGON).")0 to 3 Same as /COINServo Ready Signal Mapping (/S-RDY)(Refer to "8.11.4 Servo Ready (/S-RDY) Output.")0 to 3Same as /COINPn50F Output Signal Selections 2 − − 0000 Afterrestart−n.4th 3rddigit digit2nddigit 1stdigitTorque Limit Detection Signal Mapping (/CLT)(Refer to "8.9.5 Checking Output Torque Limiting during Operation.")0123Disabled (the above signal is not used.)Outputs the signal from CN1-25, -26 output terminal.Outputs the signal from CN1-27, -28 output terminal.Outputs the signal from CN1-29, -30 output terminal.Speed Limit Detection Signal Mapping (/VLT)(Refer to "8.7.4 Limiting Servomotor Speed during Torque Control.")0 to 3Same as /CLTBrake Interlock Signal Mapping (/BK)(Refer to "8.3.4 Setting for Holding Brakes.")0 to 3 Same as /CLTWarning Signal Mapping (/WARN)(Refer to "8.11.2 Warning Output (/WARN).")0 to 3Same as /CLT1111-41