Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

11.3 List of ParametersParameterNo.Name Setting Range Units FactorySettingSettingValidationPn001 Function Selection Application Switches 1 − − 0000 AfterrestartReferenceSectionn.4th 3rd 2nddigit digit digit1stdigitServo OFF or Alarm Stop Mode(Refer to "8.3.5 Selecting the Stopping Method After Servo OFF.")0 Stops the motor by applying dynamic brake (DB).1 Stops the motor by applying dynamic brake (DB) and then releases DB.2 Makes the motor coast to a stop state without using the dynamic brake (DB).Overtravel (OT) Stop Mode(Refer to "8.3.3 Setting the Overtravel Limit Function.")01Same setting as Pn001.0 (Stops the motor by applying DB or by coasting).Sets the torque of Pn406 to the maximum value, decelerate the motor to a stop, and then sets itto servolock state.2Sets the torque of Pn406 to the maximum value, decelerates the motor to a stop, and then sets itto coasting state.AC/DC Power Input Selection(Refer to "6.1.3 Typical Main Circuit Wirning Examples.")0 Not applicable to DC power input: Input AC power supply through L1, L2 (, and L3) terminals.1 Applicable to DC power input: Input DC power supply between + 1 andWarning Code Output Selection(Refer to "10.1.2 Warning Display.")01ALO1, ALO2, and ALO3 output only alarm codes.ALO1, ALO2, and ALO3 output both alarm codes and warning codes. While warningcodes are output, ALM signal output remains ON (normal state).1111-29