Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

8.3 Setting Common Basic Functions(3) Selecting the Motor Stop Method When Overtravel is UsedThis is used to set the stop method when an overtravel (P-OT, N-OT) signal is input while the motor is operating.Parameter Stop Mode Mode AfterStoppingPn001 n.00 Stop by dynamicbraken.01Coast* For details on stopping methods when the servo turns OFF or when an alarm occurs, refer to 8.3.5 Selecting the StoppingMethod After Servo OFF.(4) Setting the Stop Torque for OvertravelMeaningRapidly stops the servomotor by dynamic braking(DB), then places it into Coast (power OFF) Mode.Coasts the servomotor to a stop, then places it intoCoast (power OFF) Mode.n.02 Coast to a stop Stops the servomotor in the same way as when theservo is OFF (coasts to a stop), then places it intoCoast (power OFF) Mode.n.1 Decelerate to stop Zero Clamp Decelerates the servomotor with emergency stoptorque (Pn406), then places it into Zero Clamp(Servolock) Mode.n.2 Coast Decelerates the servomotor with emergency stoptorque (Pn406), then places it into Coast (powerOFF) Mode.• During torque control, these settings affect only the servomotor stopping method. After it is stopped, the servomotorenters Coast Mode regardless of the setting.• After changing these parameters, turn OFF the main circuit and control power supplies and then turn them ON again toenable the new settings.• During n.02 Coast Mode, SERVOPACK can be resumed using the servo ON signal.• TERMS• Stop by dynamic brake: Stops by using the dynamic brake (with short-circuiting by a circuit of SERVOPACK).• Coast to a stop: Stops naturally, with no brake, by using the friction resistance of the motor in operation.• Decelerate to stop: Stops by using deceleration (braking) torque.• Zero Clamp Mode: A mode forms a position loop by using the position reference zero.Pn406 Emergency Stop TorqueSpeed Position TorqueSetting Range Setting Unit Factory Setting Setting Validation0 to 800 % 800 Immediately• This sets the stop torque for when the overtravel signal (P-OT, N-OT) is input.• The setting unit is a percentage of the rated torque (i.e., the rated torque is 100%).• The value large enough to be the motor maximum torque, 800% is set as the factory setting for emergency stop torque.However, the actual output emergency stop torque is determined by motor ratings.88-21