Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

MODE/SETYASKAWACHARGEDATA/POWER200V8.1 Trial OperationStep Description Check Method and Remarks5Operate with the panel operator.YASKAWAYASKAWAMODE/SETCHARGEPanelOperatorSERVOPACKDATA/POWER6 Press the DSPL/SET or MODE/SET Key. This will turn OFF theDSPLSETpower to the servomotor. The power will remain OFF even if theMODE/SET(DSPL/SET Key)SVON or DATA/SHIFT Key is pressed for more than one second.(MODE/SET Key)SGDH-SERVOPACKSGDH-Panel OperatorSERVOPACKUse the panel operator to operate the servomotor with utility functionFn002 (Jog Mode Operation).Check that the servomotor rotates in the forward direction by UPkey, and reverse direction by DOWN key.The operation is completed when the operation is performed asdescribed below and the alarm display does not appear. Completethe Fn002 (Jog Mode Operation) and turn OFF the power.For operation method of the panel operator, refer to 7.1 Functionson Digital Operator/Panel Operator.The servomotor speed can be changed using the Pn304 (JOGSpeed). The factory setting for jog speed is 500 min -1 .PowersupplyL1L2+ 1+ 2-L1CL2CB1B2UVWCN3CN1CN2Step• JOG Mode Operation (Fn002)Display afterOperationDigital OperatorPanelOperatorDescription1 Press the DSPL/SET or MODE/SET Key to select the utilityDSPLSETfunction mode.(DSPL/SET Key)MODE/SET(MODE/SET Key)2 Press the UP or DOWN Key to select Fn002.Note: The digit that can be set will blink.3 Press the DATA/ENTER Key once, or DATA/SHIFT Key formore than one second.DATAENTERDATA/ The display shown at the right will appear, and the servomotor(DATA/ENTER Key) (DATA/SHIFT Key)(Press at least 1 s.) will enter JOG operation mode. The servomotor can be operatedwith the panel operator in this condition.4 Press the SVON or MODE/SET Key. This will turn ON theJOGSVON(SVON Key)MODE/SET(MODE/SET Key)power to the servomotor.5 Press the UP Key (forward) or DOWN Key (reverse). The servomotorwill operate as long as the key isForwardrunningpressed.8Reverserunning7 Press the DATA/ENTER Key once, or DATA/SHIFT Key forDATAENTERmore than one second to return to the Fn002 display of the utilityfunction mode.(DATA/ENTER Key)DATA/(DATA/SHIFT Key)(Press at least 1 s.)8-7