Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

7.4 Operation in Monitor Mode (Un)Step(4) Monitor Display of Reference Pulse Counter and Feedback Pulse CounterThe monitor display of reference pulse counter and feedback pulse counter is expressed in 32-bit hexadecimal.Display afterOperationDigitalOperatorPanelOperatorDescription1 Press the DSPL/SET or MODE/SET Key to selectDSPLSETthe monitor mode.(DSPL/SET Key) MODE/SET(MODE/SET Key)2 Press the UP or DOWN Key to select “Un00C” or“Un00D.”3 Press the DATA/ENTER Key once, or DATA/DATASHIFT Key for more than one second to display theENTERdata of the selected monitor number.The upper 16-bit data(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)4 Press the UP or DOWN Key to display the lower16-bit data.The lower 16-bit data5 Press both UP and DOWN Keys simultaneously(Press simultaneouly)+Press simultaneouslywhile the display on the left appears to clear the 32-bit counter data.(The display shown on the left is of the lower 16-bitdata.)6 Press the DATA/ENTER Key once, or DATA/DATASHIFT Key for more than one second to return toENTERthe display of monitor number.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)When the control power supply is turned ON, reference pulse and feedback pulse will be “0.” The countervalue increases by forward references, and decreases by reverse references.Displays the pulse number from 0 to 4294967295 in sequence. If one pulse is decreased from 0, the digitaloperator and the panel operator display 4294967295 and then decrease from this pulse number. Also, if onepulse in increased from 4294967295, the digital operator and the panel operator display 0 and increase fromthis pulse number.The feedback pulse will be 65536 pulse/rev, when using the 16-bit encoder. The feedback pulse will be131071 pulse/rev, when using the 17-bit encoder.77-31