Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

7 Digital Operator/Panel Operator7.4.1 List of Monitor Modes(b) Output Signal Monitor DisplayThe status of output signal allocated to each output terminal is displayed:When the output is in OFF (open) status, the top segment (LED) is lit.When the output is in ON (short-circuited) status, the bottom segment is lit.7654321Top: OFF (H level)Bottom: ON (L level)NumberRefer to 7.3.3 Output Circuit Signal Allocation for the relation between output terminals and signals.Display LED Output TerminalNumberNameFactory Setting1 CN1-31, -32 ALM2 CN1-25, -26 /COIN or /V-CMP3 CN1-27, -28 /TGON4 CN1-29, -30 /S-RDY5 CN1-37 AL016 CN1-38 AL027 CN1-39 AL03Seven segments in the top and bottom rows of an LED turn ON and OFF in different combinations to indicatevarious output signals.These segments ON for L level and OFF for H level.EXAMPLE• When ALM signal operates (alarm at H level.)7654 3 2 1The top segment ofnumber 1 is lit.Step(3) Operation in Monitor ModeThe example below shows how to display the contents of monitor number Un000 when the servomotor rotates at1500 min -1 .Display afterOperationDigitalOperatorPanelOperatorDescription1 Press the DSPL/SET or MODE/SET Key to select theDSPLSETmonitor mode.(DSPL/SET Key) MODE/SET(MODE/SET Key)2 Press the UP or DOWN Key to select the monitor numberto be displayed. The display shows the example ofthe data of Un000.3 Press the DATA/ENTER Key once, or DATA/SHIFTDATAKey for more than one second to display the data ofENTERUn000.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)4 Press the DATA/ENTER Key once, or DATA/SHIFTDATAKey for more than one second to return to the displayENTERof monitor number.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)7-30