Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

7 Digital Operator/Panel Operator7.3.1 Setting ParametersStep(b) Example of Changing Function SelectionThe procedure to change the setting of control method selection (Pn000.1) of the function selection basicswitches (Pn000) from speed control to position control is shown below.Display afterOperationDigitalOperatorPanel OperatorDescription1 Press the DSPL/SET or MODE/SET Key to select theDSPLSETparameter setting mode. If a parameter other than Pn000(DSPL/SET Key)is displayed, press the UP or DOWN Key to select theMODE/SET(MODE/SET Key) Pn100.Note: The enable digit blinks.2 Press the DATA/ENTER Key once, or DATA/SHIFTDATAKey for more than one second. The current data ofENTERPn000 is displayed.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)3 Press the LEFT or RIGHT or DATA/SHIFT Key toselect the first digit of current data.DATA/(DATA/SHIFT Key)4 Press the UP Key once to change to “n.0010.”(Set the control method to position control.)(UP Key)5 Press the DATA/ENTER Key once, or DATA/SHIFTDATAKey for more than one second. The value blinks and isENTERsaved.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)6 Press the DATA/ENTER Key once, or DATA/SHIFTDATAKey for more than one second to return to the displayENTERDATAPn000. The control method is changed to position control.(DATA/ENTER Key) (DATA/SHIFT Key)(Press at least 1 s.)7 To enable the change in the setting of function selection basic switches (Pn000), turn OFF the power and ON again.(c) Parameter IndicationsEach digit of the function selection parameters is defined as the hexadecimal display. The parameter displayexample shows how parameters are displayed in digits for set values.1st digit2nd digit3rd digit4th digitFor the hexadecimal display only• Pn000.0 or n.xxx: Indicates the value for the 1st digit of parameter Pn000.• Pn000.1 or n.xxx: Indicates the value for the 2nd digit of parameter Pn000.• Pn000.2 or n.xxx: Indicates the value for the 3rd digit of parameter Pn000.• Pn000.3 or n.xxx: Indicates the value for the 4th digit of parameter Pn000.7-22