Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

7 Digital Operator/Panel Operator7.2.11 Application Module Detection Results Clear (Fn014)7.2.11 Application Module Detection Results Clear (Fn014)The alarm A.E7 (application module detection error) occurs when turning ON the power for the first time whenthe SERVOPACK is used without application module after the SERVOPACK has been used with applicationmodule.Clearing application module detection results is performed as using the SERVOPACK individually withoutoperating the application module detection.Restarting again after performing the following operation will clear and reset the alarm A.E7. Then, the operationof SERVOPACK without application module is enabled.IMPORTANTBecause the parameter is set for the SERVOPACK with an application module, change the setting or initializethe parameter value (Fn005 of utility function mode) as required.StepDisplay afterOperationDigital Operator Panel Operator Description1 Press the DSPL/SET or MODE/SET Key to selectDSPLSET(DSPL/SET Key)MODE/SET(MODE/SET Key)the utility function mode.2 Press the UP or DOWN Key to select the Fn014.Note: The enabled digit blinks.3 Press the DATA/ENTER Key once, or DATA/DATASHIFT Key for more than one second, and the displaywill be as shown on theENTERleft.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)4 Press the DSPL/SET or MODE/SET Key, and thedisplay will be as shown on the left to clear theapplication module detection.DSPLBlinksSET(DSPL/SET Key) MODE/SET(MODE/SET Key)5After about one secondThe display changes from “donE” to the displayshown on the left.6 Press the DATA/ENTER Key once, or DATA/DATASHIFT Key for more than one second to return toENTERthe utility function mode.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)7-18