Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

7 Digital Operator/Panel Operator7.2.9 Motor Models Display (Fn011)7.2.9 Motor Models Display (Fn011)This mode is used for motor maintenance, set the parameter Fn011 to select the motor model check mode. If theSERVOPACK has been custom-made, you can also check the specification codes of SERVOPACKs.StepDisplay afterOperationDigital Operator Panel Operator Description1 Press the DSPL/SET or MODE/SET Key to select theDSPLSETutility function mode.(DSPL/SET Key) MODE/SET(MODE/SET Key)2 Press the UP or DOWN Key to select Fn011.Note: The enabled digit blinks.3 Press the DATA/ENTER Key once, or DATA/SHIFTKey for more than one second to display the servomotormodel and voltage code.DATAENTER(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)Motor VoltageData Model00 100VAC, 140VDC01 200VAC, 280VDC02 400VAC, 560VDCMotor TypeData Model00 SGMAH01 SGMPH02 SGMSH03 SGMGH-A(1500 min -1 )04 SGMGH-B(1000 min -1 )05 SGMDH06 SGMUH4 Press the DSPL/SET or MODE/SET Key to display theservomotor capacity.DSPLSET(DSPL/SET Key)MODE/SET(MODE/SET Key)Motor capacity in units of 10 WThe above example indicates 100 W.5 Press the DSPL/SET or MODE/SET Key, and theencoder type and resolution code will be displayed.DSPLSET(DSPL/SET Key)MODE/SET(MODE/SET Key)Encoder TypeData Type00 Incremental01 AbsoluteEncoder ResolutionData Resolution13 13-bit16 16-bit17 17-bit20 Reserved6 Press the DSPL/SET or MODE/SET Key to display theSERVOPACK’s code for custom orders.Note: The display “y.0000” means standard model.DSPLSET(DSPL/SET Key)MODE/SET(MODE/SET Key)Code for custom orders7 Press the DATA/ENTER Key once, or DATA/SHIFTDATAKey for more than one second to return to the utilityENTERfunction mode display Fn011.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)7-16