Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

7.2 Operation in Utility Function Mode (Fn)StepDisplay afterOperationDigital Operator Panel Operator Description7DATAENTER(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)Press the DATA/ENTER Key once, or DATA/SHIFTKey for more than one second.Fn003 display appears again.The motor will be servo OFF status.INFOForward run prohibited (P-OT) and reverse run prohibited (N-OT) signals cannot be input during the zero-point searchoperation.7.2.4 Parameter Settings Initialization (Fn005)This function is used when returning to the factory settings after changing parameter settings.Pressing the DSPL/SET or MODE/SET Key during servo ON does not initialize the parameter settings.After initialization, turn OFF the power supply and then turn ON again.IMPORTANTInitialize the parameter settings with the servo OFF.StepDisplay afterOperationDigital Operator Panel Operator Description1 Press the DSPL/SET or MODE/SET Key to select theDSPLSET(DSPL/SET Key)MODE/SET(MODE/SET Key)utility function mode.2 Press the UP or DOWN Key to select Fn005.Note: The enabled digit blinks.3 Press the DATA/ENTER Key once, or DATA/SHIFTDATAENTERKey for more than one second, and the display will beas shown on the left.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)74 Press the DSPL/SET or MODE/SET Key. Then, theDSPLparameters will be initialized.SET(DSPL/SET Key)MODE/SETDuring initialization, the display shown on the left(MODE/SET Key)blinks.5 End of initialization When the initialization of parameter setting completes,the display shown on the left blinks for aboutone second.6 After about onesecondThe display changes from “donE” to the displayshown on the left.7 Press the DATA/ENTER Key once, or DATA/SHIFTDATAENTERKey for more than one second to return to the utilityfunction mode display Fn005.(DATA/ENTER Key)DATA(DATA/SHIFT Key)(Press at least 1 s.)7-11