Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

7 Digital Operator/Panel Operator7.2.1 List of Utility Function Modes7.2 Operation in Utility Function Mode (Fn)7.2.1 List of Utility Function ModesThis section describes how to apply the basic operations using the panel operator to run and adjust the motor.The following table shows the parameters in the utility function mode.ParameterReferenceFunctionRemarksNo.SectionFn000 Alarm traceback data display − 7.2.2Fn001 Rigidity setting during online autotuning ◦ 9.2.4Fn002 JOG mode operation ◦ 8.1.1Fn003 Zero-point search mode ◦ 7.2.3Fn004 Fixed parameter ◦ −Fn005 Parameter setting initialization ◦ 7.2.4Fn006 Alarm traceback data clear ◦ 7.2.5Fn007 Writing to EEPROM moment of inertia ratio data obtained from online◦ 9.2.7autotuningFn008 Absolute encoder multiturn reset and encoder alarm reset ◦ 8.4.5Fn009 Automatic tuning of analog (speed, torque) reference offset ◦ 8.5.38.7.3Fn00A Manual adjustment of speed reference offset ◦ 8.5.3Fn00B Manual adjustment of torque reference offset ◦ 8.7.3Fn00C Manual zero-adjustment of analog monitor output ◦ −Fn00D Manual gain-adjustment of analog monitor output ◦ −Fn00E Automatic offset-adjustment of motor current detection signal ◦ 7.2.6Fn00F Manual offset-adjustment of motor current detection signal ◦ 7.2.7Fn010 Password setting (protects parameters from being changed) − 7.2.8Fn011 Motor models display − 7.2.9Fn012 Software version display − 7.2.10Fn013 Multiturn limit setting change when a Multiturn Limit Disagreement Alarm ◦ 8.4.8(A.CC) occursFn014 Application module detection results clear ◦ 7.2.11Note: When the parameters marked with “◦” in remarks column or in Pn are set for Password Setting(Fn010), the indication shown below appears and such parameters cannot be changed.Blinks forone second7-8