Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

7.1 Functions on Digital Operator/Panel Operator7.1.2 Key Names and FunctionsKey names and functions for the digital operator and the panel operator are explained below.Set parameters and JOG operation, and display status using the panel operator.Digital OperatorSERVOPACKALARMRESETJOGSVONDIGITALOPERATORJUSP-OP02ADSPLSETDATAENTERYASKAWASERVOPACKDigital OperatorALARMRESET(RESET Key)DSPLSET(DSPL/SET Key)DATAENTER(DATA/ENTER Key)(UP Key)(DOWN Key)(RIGHT Key)KeyPanel Operator+Press simultaneouslyMODE/SET(MODE/SET Key)DATA/(DATA/SHIFT Key)(UP Key)(DOWN Key)−FunctionTo reset the servo alarm.Note 1. The servo alarm can be reset by /ALM-RST (CN1-44)input signal.2. The servo alarm need not be reset if the control powersupply is turned OFF.To select a basic mode, such as the status display mode, utilityfunction mode, parameter setting mode, or monitor mode.Can be also used to set the data.To display parameter setting and set value.Press the UP Key to increase the set value.For JOG operation, this key is used as Forward Run Start Key.Press the DOWN Key to decrease the set value.For JOG operation, this key is used as Reserve Run Start Key.Press the RIGHT Key to shift to the next digit on the right.Panel Operator(LEFT Key)DATA/(DATA/SHIFT Key)Press the LEFT or DATA/SHIFT Key to shift to the next digit onthe left.JOGSVON(SVON Key)MODE/SET(MODE/SET Key)Press the SVON or MODE/SET Key to perform servo ON/OFFin the JOG operation with the operator.7IMPORTANTWhen an alarm occurs, remove the cause, and then reset the alarm. Refer to 10.1 Troubleshooting.7-3