Sigma-II Series SGM*H/SGDH USER'S MANUAL - Esco Drives ...

7 Digital Operator/Panel Operator7.1.1 Connecting the Digital Operator7.1 Functions on Digital Operator/Panel OperatorThis section describes the basic operations of the digital operator (hereinafter called the digital operator) and thepanel operator (hereinafter called the panel operator) for setting the operating conditions. Set parameters andJOG operation, and display status using these operators. For the operation of the digital operator (Model: JUSP-OP02A-2), refer to Σ-II Series SGMH/SGDM Digital Operator Operation Manual (TOE-S800-34).7.1.1 Connecting the Digital OperatorTwo types of digital operators are available. One is a built-in operator that has a panel indicator and switcheslocated on the front panel of the SERVOPACK. This type of digital operator is also called a panel operator. Theother one is a hand-held operator (JUSP-OP02A-2 digital operator), which can be connected to the SERVO-PACK with connector CN3 of the SERVOPACK.There is no need to turn OFF the SERVOPACK to connect this hand-held operator to the SERVOPACK. Refer tothe following illustrations to connect the digital operator to the SERVOPACK.Digital OperatorJUSP-OP02A-2Panel OperatorYASKAWASERVOPACKSGDH-200V. . . . .DIGITALSERVOPACK OPERATORJUSP-OP02AMODE/SETDATA/ALARMRESETDSPLSETJOGSVONDATAENTERYASKAWACN3A dedicated cable is used toconnect the digital operatorto the SERVOPACK.SERVOPACKIMPORTANTIf the digital operator is connected to the SERVOPACK, the panel operator does not display anything.7-2