Cisco Catalyst 6500 Supervisor 2T Architecture - Ipland

White PaperA high-level overview of the Supervisor 2T board layout is shown in the diagram below.Figure 1.Supervisor 2T Board LayoutA summary of the Supervisor 2T critical features is listed in the table below:Table 1.Important Baseboard Features of Supervisor 2TFeatureSwitch fabric typeForwarding engine daughter cardCPU daughter cardUplink portsUSB portsManagement PortsManagement LEDMedia slotForwarding performanceDescription2080 Gbps (2 Tbps) crossbar switch fabricPFC4 or PFC4XLMSFC52 x 10 GE (X2 optic support)3 x GE (SFP support)2 x USB (1 x Type-A and 1 x Type-B)Serial console port (RJ-45)Connectivity management processor Ethernet port (RJ-45)Blue beacon LEDCompact flash slot (Type II)Up to 60 Mpps for L2, IPv4, and MPLS trafficUp to 30 Mpps for IPv6 trafficThe following sections provide more details on each of the major components of the Supervisor 2T.System Level RequirementsThe Supervisor 2T is designed to operate in any E-Series 6500 chassis. The Supervisor 2T will not be supported inany of the earlier non E-Series chassis. The table below provides an overview of the supported and non-supportedchassis for Supervisor 2T.Table 2.Chassis Options for Supervisor 2TSupported ChassisNon Supported Chassis6503-E, 6504-E, 6506-E, 6509-E, 6509-V-E, 6513-E 6503, 6506, 6509, 6509-NEB, 6509-NEB-A, 6513, 7603, 7603-S, 7604, 7606,7606-S, 7609, OSR-7609, 7609-S, 7613© 2011-2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Partner Confidential Information. Page 4 of 46