safety compliance testing for fmvss no. 114 theft protection

More documents

Recommendations

Info

8FMVSS 114, ROLLAWAY PREVENTIONDATA SHEET 3(for vehicles equipped with transmission with a “park” position)VEH. NHTSA NO.: CA0209 TEST DATE: 03/29/10REQUIREMENT S5.2.1 PASS FAILThe starting system prevents key removal in ALL gear selection controlpositions except “park”.Yes X No____Can the gear selection control be placed between each gear selectionposition and will it remain there without assistance?Yes No XXIf yes, can the key be removed from the starting system?Yes No____If the key can be removed from the vehicle starting system when thegear selection control is not locked in “park”, a mechanism shall existwhich, upon key removal, the vehicle transmission or gear selectioncontrol shall become locked in “park” as the direct result of removing thekey. If such a mechanism exists, describe the mechanism and itsfunction:REQUIREMENT S5.2.2 PASS FAILThe gear selection control is locked in the “park” position when the key isremoved from the starting system.Yes X No______XREMARKS: If the electronic intelligent access (IA) key is not present inside the vehicle when theengine is shut off, the fast restart feature allows the driver to restart the vehicle for up to 20 seconds,even though the IA key is not present.
9DATA SHEET 3 continuedELECTRICAL FAILURE (Battery Discharge)REQUIREMENT S5.2.3 PASS FAILIn the event of an electrical failure, key removal from the starting system whenthe transmission or gear selection control is not locked in “park” is permitted”.Yes X No____The vehicle is equipped with an override device that permits key removal fromthe starting system when the transmission or gear selection control is notlocked in “park”.Yes______ No XIf yes, select the type of override device equipped:Opaque Cover_______ No Cover___________Describe the override device design and mode of activation (if equipped):N/AFILL IN THE SECTION BELOW THAT APPLIES:OVERRIDE WITH AN OPAQUE COVER:The opaque surface cover prevents sight of and use of override device.Yes_____ No______The opaque surface cover can only be removed by using a screwdriver orother tool.Yes_____ No______N/AAs a direct result of removing the key from starting system, the following isprevented:Steering______ or Self-Mobility______OVERRIDE WITH NO COVERThe override device requires the use of a tool to activate.Yes_____ No______Simultaneous activation of the override device and removal of key from startingsystem is required.Yes_____ No______N/AAs a direct result of removing the key from the starting system, the following isprevented:Steering_______ or Self-Mobility_______REMARKS:
Page 1 and 2: REPORT NUMBER 114-GTL-10-009SAFETY
Page 3 and 4: 1. Report No. 2. Government Accessi
Page 5 and 6: 1SECTION 1PURPOSE OF COMPLIANCE TES
Page 7 and 8: 3SECTION 3TEST DATA3.0 TEST RESULTS
Page 9 and 10: 5GEAR SELECTION CONTROLDescribe the
Page 11: 7FMVSS 114, THEFT PROTECTIONDATA SH
Page 15 and 16: 11DATA SHEET 3 continuedVEHICLE FAC
Page 17 and 18: 13SECTION 4TEST EQUIPMENT LISTITEM
Page 19 and 20: 2010 LINCOLN MKS FIGURE 5.1NHTSA NO

safety compliance testing for fmvss no. 114 theft protection

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?