Thor's Hammer Owner's Manual - Wilson Audio

S e c t i o n 4 . 1 – S p i k i n g T h o r ’ s H a m m e rSection 4.1 – Spiking Thor’s HammerThe Thor’s Hammer comeswith a set of heavy duty spikesthat provide acoustical isolationas well as optimal height placementfor your Thor’s Hammer.Brass disks that fit beneath thespikes are included for installationswhere spikes might damagethe floor surface (such aswood floors).Note: Thor’s Hammer weighsover four hundred pounds(181.43 Kg). Two strong individualsare required to safelyinstall spikes.After determining theThor’s Hammer’s position, assemblethe spikes as follows:Assembly – Vertical PlacementFigure 6 – Install Spikes into the Threaded Holes onBottom1. Remove the casters from the bottom of the Thor’s Hammer2. Carefully tilting the Thor back, exposing the two front spikes holes beneath,insert threaded bolts in the bolt holes in the front of the subwooferuntil they are flush with the inner surface visible through the acousticport. Make sure the Allen key end is facing downward.3. Screw the acoustical diode onto the bolt until it fits snugly against theW i l s o n A u d i o S p e c i a l t i e s29