Proposed Renovation of Former Jacinto Building - Clark Freeport Zone

Lighting Fixtures and LampAll lighting fixtures and lamps are as specified and listed on lighting fixtureschedule.For fluorescent lamp, it shall be 32-watt rapid start daylight white. All fluorescentballast shall be 108-277 v auto volt, electronic ballast, high power factor, of goodquality materials and approved by the Bureau of Product Standards (BSP).Luminaire housing shall be die cast aluminum with electro gray finish for long lifeperformance. It shall be pole/wall mounted with wattage capacity from 200 wattsto 400 watts Metal Halide. Ballast shall be 230 volt with ignitor and capacitor andshall have universal two (2) bolt slip fitter and adjustable mogul or E40 socket.Standard construction is IP65 with breathing seal to prevent contaminant fromentering the optical assembly. Ball latch shall be stainless steel and precisiondesign refractor to uniformly laminate wide area.For Perimeter Lights, Lamps shall be Metal Halide, 400-watts, 28,000 lumens, andshall conform to ANSI and UL Standards, and shall have a constant wattagetransformer CWA or regulator, open type high power factor. Ballast shall bedesigned to operate on the voltage system to which they are connected. Providesingle lamp ballasts with a minimum starting temperature of minus 30 degreesCelcius (C). Ballast shall be constructed so that open circuit operation will notreduce their average life. Metal Halide ballast shall have a solid state ignitor/starterwith an average life in the pulsing mode of 15,000 hr. and a case temperature of75 degrees C. Average life is defined as the time after which 50 percent will havefailed and 50 percent will have survived under normal conditions.Item 1102 –Power Load Centre, Switchgear and Panel boardThis item shall consist of the furnishing and installation of the power load centreunit low voltage switchgear and distribution panel boards at the location shown orthe approved plans complete with circuit breakers, cabinets and all accessories,completely wired and ready for service.All materials shall be brand new and shall be of the approved type. It shallconform with the requirements of the Philippine Electrical Code and shall bear thePhilippine Standard Agency (PSA) mark.The molded case circuit breakers shall be of the thermal-magnetic type having metripping characteristic on overload and instantaneous trip on short circuits, shall beequipped with arc quenchers, shall have a quick-made and quick- break togglemechanism, and shall have trip-free operating handles. Each multi-pole breakershall have a common trip so that an overload on one pole with automaticallycauses all poles of the breakers to open. The circuit breakers shall have aninterrupting rating of not less than 20,000 symmetrical amperes at 230 volts.103Clark Development Corporation Proposed Renovation of Former Jacinto Building(Motorpool, Records, Warehouses and Maintenance Area)