SAM4s SPS-300 Series Operators Manual.pdf

Clearing MemoryBefore you use your SPS-300 Series ECR for the first time, you must perform a memory allclear to insure that all totals and counters are cleared and that the default program is installed.CAUTION: The procedures described in this area are security sensitive. Clearing theSPS-300 Series memory after the register is put into service will erase all programmingas well as totals and counters. Do not share this information with unauthorized usersand distribute the key marked “C” only to those you may want to perform thesefunctions.SPS-320/SPS-340 Memory All Clear1. Turn the power switch located on the right side of the register to the OFF position.2. Turn the control lock to the S position.3. Press and hold the key position where the CHECK key is located on the defaultkeyboard layout.SPS-320 and SPS-340Press and hold theCHECK key positionduring power-up in Smode.4. Continue to hold the appropriate key while turning the power switch to the ONposition. The message “RAM ALL CLEAR" displays.5. Press the upper left key of the keyboard, then the lower left key, then the upper rightkey, and finally press the lower right key.1 3SPS-320SPS-3402 46. The display reads: RAM (16M). After a short delay, the message: "OK” will displayif the RAM check is good. Memory is cleared, the default program is installed andthe RAM CLEAR receipt is printed. The display now reads:2-STATION PRINTER : ‘CASH’ Key1-STATION PRINTER : ‘CLEAR’ Key7. If you have an ER-320 (one printer station), press CLEAR.If you have an ER-340 (two printer stations), press CASH.30 • Getting Started SAM4s SPS-300 Operator's & Programming Manual v1.2