SAM4s SPS-300 Series Operators Manual.pdf

Register NumberSingle ItemSplit PricingStock (PLU Stock)Surcharge (Item)Surcharge (Sale)Tareloans to the cash drawer.The number of the register can be set and printed on each receipt. If the merchant uses morethan one register, or has more than one location, the register where a transaction took place orreport was taken is easily identified.The transaction is finalized automatically when a single item PLU is registered as the firstitem in a sale. Single item status is used to speed transaction entry when an item is normallysold in a one-item sale, for example, a pack of cigarettes, a newspaper or an admission ticket.Often merchants price items in multiples, for example 3 for $1. The register will compute theprice of items when the exact quantity is not purchased. If the customer chooses to buy 2items at 3 for $1, enter 2, press the X/TIME key, enter 3, press the X/TIME key and thenenter the price and the PLU. The register will compute the price for the items purchased.Each PLU reports an activity counter. Normally the activity counter increments (adds) and isreset when a PLU Z-report is taken. You can choose to use the PLU activity counter as astock counter. If used as a stock counter, each PLU activity will reduce the count. A separateprogram allows you to add to the stock count or enter a new stock count. Stock counts arenot reset when PLU Z-reports are taken.An item percent surcharge adds a percentage to the price of an item. This addition nets thePLU total.A sale percent surcharge adds a percentage to the entire sale.Tares are container weights. If you are using the scale function, you can preset up to 5different tare weights. The tare can be subtracted automatically when a specific PLU isregistered, or manually inputting the tare number and pressing the TARE key can subtract thetare. Tare #5 can be programmed for entering tare weights manually.Tax Computation by Rate/Tax Computation by TableTax ExemptIn the simplest method of tax calculation, the register is set with a tax rate (or rates) and thetaxes are computed by a percentage calculation. In some cases, a tax that is entered as apercentage does not follow exactly the tax charts that apply in your area (even if the tax chartis based on a percentage). In these cases, we recommend that you enter your tax using taxtable programming. This method will match tax collection exactly to the break points of yourtax table.Tax exempt is used to exclude the tax from an entire sale.SAM4s SPS-300 Operator's & Programming Manual v1.2 Glossary • 289