SAM4s SPS-300 Series Operators Manual.pdf

Local Batch Status Explanations:(From Left to Right)o Batch Status C=Closed/O=Open/X=Incomplete4 Batch Number3 Batch Transaction Count3 Batch Item Count2.00 Batch Balance0 Batch Forwarded Transaction Count.00 Batch Forwarded BalanceDial In Load/Dial Out LoadFor Legacy DataTran equipment:If instructed by Datacap support, you can use these options to update DataTran software.Choose Enable Dial In Load to allow Datacap to call the DataTran and send updates. ChooseEnable Dial Out Load to call Datacap to connect. You will be required to enter the phonenumber and terminal I.D. (password) which will be given to you by Datacap.For TwinTran:When a TwinTran is first installed, the dealer must do a Dial Out Load through the IPconnection. If, for any reason, the internet is not available, the device cannot be loaded. If itis being installed at a location where the Internet is not currently operational and the customerwants to use the dial out method for approvals, the procedure below must be done at alocation where the internet is working.To load a TwinTran using a Sam4s register;With the TwinTran connected to the register and an active Ethernet line, enter into the DialOut mode. At the Phone number field enter the number “1”. If the register uses the codeentry method for alpha characters enter the 3 digit code (049). At the Enter ID prompt, enterthe serial number of the TwinTran. Select Tone phone connection. The TwinTran will callDatacap’s host PC and load itself. This takes approximately 20 seconds. After the TwinTran isloaded, one successful credit transaction must be done. After that the unit can be connected asthe customer wishes.Tip OperationFollow the prompts to enter the record number, original transaction amount and tip amount.If the record number and transaction number are valid, the tip amount is entered in the batchand a tip entry chit prints.SAM4s SPS-300 Operator's & Programming Manual v1.2 Integrated Payment Appendix • 271