SAM4s SPS-300 Series Operators Manual.pdf

Machine No.The machine number is printed on the register receipt. Program a machine number so thatany receipt can be identified with the store or register where the transaction took place. Themachine number may be a different number than the IRC register number programmed inIRC programming (see "IRC Options" in the "Service Mode Programming" chapter.)1. From the PGM control lock position menu, press 00 for MORE. ThePROGRAM MODE page 2 screen displays. Press PAGE DOWN to view theremainder of the page 2 program options.2. From the PROGRAM MODE page 2 screen, press 7 for MACHINE NO. TheMACHINE # PROG. screen displays:MACHINE # PROGRAMMACHINE #0Training Mode Password3. Type the machine number, up to 5 digits, press CASH.If you wish to use training mode, you must program a password that you will use to entertraining mode. The password may be up to 4 digits long, however, if you choose to use apassword less that for digits, you must enter preceding zeros to complete a 4 digit entry. Forexample, if you program the password to be "77", you must type "0077" when enteringtraining.1. From the PGM control lock position menu, press 00 for MORE. ThePROGRAM MODE page 2 screen displays. Press PAGE DOWN to view theremainder of the page 2 program options.2. From the PROGRAM MODE page 2 screen, press 9 for TRAINING MODEP/W. The TRAINING MODE P/W screen displays:TRAINING MODE PASSWORDPASSWORD :03. Type the password, up to 4 digits, press CASH.SAM4s SPS-300 Operator's & Programming Manual v1.2 Program Mode Programming • 243