SAM4s SPS-300 Series Operators Manual.pdf

Initial ClearCAUTION: Do not share this information with unauthorized users. Distribute thePGM Mode key only to those you may want to perform this function.The initial clear function allows you to exit any register activity and return to a beginning orcleared state. Any transaction that is in progress will be exited and totals for that transactionwill not be updated.Here are some reasons you may want to perform an initial clear:The register is in an unknown state, and you wish to exit the current program ortransaction without following normal procedures.You have performed a function that includes a compulsory activity and you wish tobypass the compulsion.An initial clear may be necessary as part of servicing, or troubleshooting.Perform this procedure only as necessary. Contact your SAM4s dealer first if you havequestions about operating or programming your SAM4s SPS-300.To Perform an Initial Clear:1. Turn the power switch located on the right side of the register to the OFF position.2. Turn the control lock to the PGM position.3. Press and hold the key position where the SUBTOTAL key is located on the defaultkeyboard layout.4. While continuing to hold the SUBTOTAL key, turn the power switch to the ONposition. When the “Initial Clear Service” message displays release the SUBTOTALkey.5. The message "INITIAL CLEAR OK!” prints when the initial clear is complete. Toresume operations, you will need to sign on a clerk.SPS-320 and SPS-340Press and hold theSUBTL key positionduring power-up inPGM mode.SPS-345Press and hold theSUBTOTAL keyposition duringpower-up in PGMmode.24 • Introduction SAM4s SPS-300 Operator's & Programming Manual v1.2