SAM4s SPS-300 Series Operators Manual.pdf

10. Press OK Button. The download takes about 3 minutes. At the PC, thescroll bar will track the progress of the download. At the ECR, The displaywill flash (Current program is being erased), after a few seconds, the displaywill continue to flash, but at a slower rate. This continues for about 3minutes while the new program is being loaded.Clear Current Batch11. When complete, the message Completed displays at thePC. Click OK andthe Download program will close. At the ECR, when the load is complete, arapid beep-beep-beep will be heard, and the display will flash rapidly. Turnthe power switch to OFF, the program update is complete.12. Disconnect the PC cable.13. Perform a memory all clear on the ECR. The ECR is now ready to programor to load a previously saved end-user program.The clear batch command erases all the current batch transactions from the DataTran memoryeven if they have not been settled. A LOCAL TRANSACTION INQUIRY should be printedprior to clearing the batch. This will ensure that the operator has the transaction detail to reenterif required.This operation should only be done under the direction of DATACAP.136 • S-Mode Programming SAM4s SPS-300 Operator's & Programming Manual v1.2