SAM4s SPS-300 Series Operators Manual.pdf

Program Backup and LoadYou can use an SD flash memory card to backup and load (restore) the full program.CAUTION: The program data is saved in a separate folder on the SD card named withthe store name that is set on page 18 of system options. When backing up and restoringdata, the store name must be programmed. Note that the default store name is“STORE_A”.Backing Up the Program to an SD Card1. Insert the SD card in the register’s SD slot.2. Turn the control lock to the S position.3. From the second page of the Service Mode menu, select “9 SD CardOperation”.4. From the SD Card Operation menu select “1 Program Backup”. The SPS-300will write the program files to the folder: SPS300/PRGBACK/STORENAME(where store name is the name programmed on page 18 of system options.) Inthe example below, the store name is “1719”.5. After a short pause, the register will print confirmation of the successful uploadwith the message “UPLOAD PASS” for each program segment. Below is anExplorer view of the backed up files.Restore Program from the SD CardCAUTION: Memory allocation must be set the same as the saved program. Be sure toprint out the memory allocation so that it can be re-entered before restoring the program.1. Set the store name to match the name of the store folder you wish to restore.2. Insert the SD card in the register’s SD slot.3. Turn the control lock to the S position.4. From the second page of the Service Mode menu, select “9 SD CardOperation”.5. From the SD Card Operation menu select “2 Program Load”.6. The register will print confirmation of the successful upload with the message“DOWNLOAD PASS” for each program segment.128 • S-Mode Programming SAM4s SPS-300 Operator's & Programming Manual v1.2