SAM4s SPS-300 Series Operators Manual.pdf

TESTRS-232MCRDALLASSDPRINTINGPATTERNNOTESSelect LOOP TEST PORT 1, LOOP TEST PORT 2, or LOOP TESTIRC. (to loop test port 1 or 2 , a loop back connector must be inplace.) Then after a moment, the display indicates NG (not good) orOK.Select to test read a magnetic card.Option not availableInsert an SD card and select to run a read/write test. The results willprint. Press CLEAR to exit the test.ENDLESS PRINTING and LIFE TEST PRINT are factory tests.Toggle the power switch on and off to end the test.Memory All ClearBefore you use your SPS-300 Series ECR for the first time, you must perform a memory allclear to insure that all totals and counters are cleared and that the default program is installed.Go to “Clearing Memory” on page 30 to complete this procedure.Clear All TotalsThis selection clears all totals and counters, including the grand total.1. From SERVICE MODE menu press 1 to display the CLEAR ALL TOTALSscreen:CLEAR ALL TOTALSARE YOU SURE ?N2. Press the YES/NO key to display Y at the "ARE YOU SURE ?" question. PressCASH.3. The display reads: "PLEASE WAIT". The message "ALL TOTAL CLEAR" isprinted and the screen returns to the SERVICE MODE menu.114 • S-Mode Programming SAM4s SPS-300 Operator's & Programming Manual v1.2