Sekonic L-608 Manual

More documents

Recommendations

Info

6. Advanced Functions6. Upon setting completion, the Wireless flash radio triggering mode or Wireless multiple flashradio triggering mode is selected using the Jog wheel while the Mode set button is pressed. Forother settings of the measurement, see page 16.7. Confirm that the meter and the radio receiver are set to the same channel number. The flashunit will fire when the measurement button of the meter is pressed and measurements can bemade at the same time.Reference:• Refer to the receiver instruction manual for the receiver operating method.• Maximum controllable distance of the radio flash trigger system differs depending on theplacement of the device, direction and other factors.1. Confirm the direct visible range between the transmitter and receiver.2. Place the meter and receiver away from large metal objects, concrete, objects withlarge moisture content (both people and trees fall into the category) and so forth.3. Secure the radio receiver in place by using Velcro tape or mounting 1/4-20 thread.Be sure that the entire length of the receiver antenna is higher than the flash pack atthis time. Avoid contact between the receiver antenna and metal objects at all times.4. Depending on the location, there may be cases when the receiver is incapable ofreceiving any radio signals whatsoever.There are various possible reasons for this such as radio signals reflected from nearbyobjects. This can generally be resolved by shifting the device slightly in one directionor another.In addition, confirm that the device is not placed behind objects that readily absorb ordeflect radio signals such concrete, metal, low hills, etc.NOTE:• The radio flash system may be used only in countries where a permit for the controlfrequency has been issued by the government office in charge.-38-
7. AccessoriesMini Light Receptor (Sold separately)• Incident light receiving unit with a compact 12mm diameterlight receiving surface.• For measuring narrow areas used for photographing smallsubjects or copy work.Synchro cord (Sold separately)• This is a five-meter long cord with three plugs. An exposuremeter, a camera, and a flash can all be connected at thesame time. This is convenient when measurements aremade, because it is not necessary to plug and unplug thesynchro cord.18% Gray Card (Sold separately)• 18% gray card with cover (110mm x 102mm, 4 1/4" x 3 1/2"), folds to 2 3/4" x 4 3/4", and fits in a shirt pocket.• It provides accurate exposures regardless of reflected ratio of the subject and surroundings.-39-
Page 1 and 2: Super Zoom MasterL-608/L-608Operati
Page 3 and 4: Congratulations on your purchase of
Page 5 and 6: 1. Parts Designationq Lumisphere re
Page 7 and 8: q Measuring Mode IconsAmbient (see
Page 9 and 10: 3. Before Using4. Replacing battery
Page 11 and 12: 4. Basic Operation1. Incident or re
Page 13 and 14: 4. Basic Operation3. Setting DIP Sw
Page 15 and 16: 4. Basic Operation5. When set for r
Page 18 and 19: 5. Measurement1-2 Aperture Priority
Page 20 and 21: 5. Measurement1-4 Cinematography1.
Page 22 and 23: 5. Measurement2. Measuring flash li
Page 24 and 25: 5. Measurement3. When the Measuring
Page 26 and 27: 5. MeasurementCAUTION:• There is
Page 28 and 29: 6. Advanced Functions1. Memory func
Page 30 and 31: 6. Advanced Functions2. Turn any se
Page 32 and 33: 6. Advanced Functions5. How to use
Page 34 and 35: 6. Advanced Functions7. How to use
Page 36 and 37: 6. Advanced Functions9. Flash analy
Page 38 and 39: 6. Advanced Functions*1 1/10 stop f
Page 40 and 41: 6. Advanced Functions11. Wireless F
Page 44 and 45: 7. AccessoriesWireless flash radio
Page 46 and 47: 8. Technical DataAperture: f/0.5 to
Page 48 and 49: 10. Care and MaintainanceNOTE:• A
Page 50 and 51: Memo-46-
Page 52: 7-24-14, OIZUMI-GAKUEN-CHO, NERIMA-

Sekonic L-608 Manual

Create successful ePaper yourself

Delete template?

Save as template?