Sekonic L-608 Manual

1-3 EV modeOpen the Battery compartment cover !6 and slide the EV DIP switch 1 (see page 9) to the ONposition.1. Hold down the Mode set button !0 and turn theJog wheel t to select value mode.5. MeasurementMODE2. Press the Measuring button !5 to make ameasurement. Release the Measuring button tocomplete the measurement. The measured value(EV value) at that time will be displayed.ShutterspeedAt the same time, the shutter speed will bedisplayed in the digital display area, and thecorresponding f stop will be displayed on the analogscale.While pressing the measuring button, the metermeasures continuously until it is released.f stopEV valueReference:• “E.u” (Exposure under) or “E.o” (Exposure over) on the T or F display area and “U”or “O” onthe analogscale appears when the combination of shutter speed and aperture are outsidethe display range. Changing the shutter speed or aperture with the Jog wheel will allow youto find a combination that is possible.If the “E.u” or “E.o” readout and “U”or “O” on the analogscale blink, this indicates that thelight level is beyond of the measurement range of the light meter. Adjust the lighting in thiscase.-15-