Avamar 5.0 Exchange Client User Guide.pdf - EMC Community ...

Configuring an Exchange Server 2003 Server for Message Level Backups and RestoresINSTALLING/UNINSTALLING AVAMAR EXCHANGE CLIENTConfiguring an Exchange Server 2003 Server for MessageLevel Backups and RestoresTIP: If you do not intend to perform message level backupsand restores (your intent is to only perform full databasebackups and restores), you can skip this procedure.IMPORTANT: If your Exchange Server 2003 server isdeployed in a high-availability configuration using Windowsclusters, you must perform this entire procedure on all nodesin the cluster with the exception that only the active nodecan have the backup agent service running at any one time.However, all nodes (including inactive nodes) must be configuredto start and run the backup service as AvamarBackupUser.Task ListIf you intend to perform message level backups and restores, you must performthe following tasks:• Create New “AvamarBackupUser” User Account and Mailbox That UsesStatic Profile (32-bit) (page 29)- or -• Create New “AvamarBackupUser” User Account and Mailbox That Uses aTemporary MAPI profile (32-bit) (page 32)NOTE: EMC Avamar Exchange Client 5.0 introduces a newwizard to configure the AvamarBackupUser account with thecorrect settings needed for message-level backups andrecoveries. However, some users may prefer to manuallycreate the AvamarBackupUser account using the methodsavailable in Avamar Exchange Client 4.1 and earlier. AvamarExchange Client 5.0 still supports this manual method. Referto Appendix B — Manually Creating the AvamarBackupUserAccount (page 78)Create New “AvamarBackupUser” User Account and MailboxThat Uses Static Profile (32-bit)This section contains steps that must be performed on one node in the cluster,followed by steps that must be performed on all nodes in the cluster.AVAMAR 5.0 • AVAMAR EXCHANGE CLIENT USER GUIDE 29