Proline Promass 83E/F/O Modbus RS485 Operating Instructions

CommissioningRecommended settings Quick Setup "Pulsating Flow"Proline Promass 83 Modbus RS485HOME position F MEASURAND O QUICK SETUP F QS PULSATING FLOW (1003)Function No. Function name Selection with OSTo next function with F1003 QS PULS. FLOW YESAfter F is pressed by way of confirmation, theQuick Setup menu calls up all the subsequentfunctions in succession.Basic configuration2002 DISPLAY DAMPING 1 s3002 TOTALIZER MODE (DAA) BALANCE (Totalizer 1)3002 TOTALIZER MODE (DAB) BALANCE (Totalizer 2)3002 TOTALIZER MODE (DAC) BALANCE (Totalizer 3)Signal type for "CURRENT OUTPUT 1"4004 MEASURING MODE PULS. FLOW4005 TIME CONSTANT 1 sSignal type for "FREQ./PULSE OUTPUT 1" (for FREQUENCY operating mode)4206 MEASURING MODE PULS.FLOW4208 TIME CONSTANT 0 sSignal type for "FREQ./PULSE OUTPUT 1" (for PULSE operating mode)4225 MEASURING MODE PULS. FLOWOther settings8005 ALARM DELAY 0 s6400 ASSIGN LOW FLOW CUTOFF MASS FLOW6402 ON-VALUE LOW FLOW CUT OFF Setting depends on diameter:DN 1 = 0.02 [kg/h] or [l/h]DN 2 = 0.10 [kg/h] or [l/h]DN 4 = 0.45 [kg/h] or [l/h]DN 8 = 2.0 [kg/h] or [l/h]DN 15 = 6.5 [kg/h] or [l/h]DN 15 FB = 18 [kg/h] resp. [l/h]DN 25 = 18 [kg/h] resp. [l/h]DN 25 FB = 45 [kg/h] resp. [l/h]DN 40 = 45 [kg/h] resp. [l/h]DN 40 FB = 70 [kg/h] resp. [l/h]DN 50 = 70 [kg/h] resp. [l/h]DN 50 FB = 180 [kg/h] resp. [l/h]DN 80 = 180 [kg/h] or [l/h]DN 100 = 350 [kg/h] or [l/h]DN 150 = 650 [kg/h] or [l/h]DN 250 = 1800 [kg/h] or [l/h]DN 350 = 3250 [kg/h] or [l/h]6403 OFF-VALUE LOW FLOW CUTOFF 50%6404 PRESSURE SHOCK SUPPRESSION 0 sBack to the HOME position: Press and hold down Esc key X for longer than three seconds or Repeatedly press and release Esc key X Exit the function matrix step by stepÆÆFB = Full bore versions of Promass IPage 64 • MN0M030Issue/Rev. 0.2 (12/12)