Proline Promass 83E/F/O Modbus RS485 Operating Instructions

Proline Promass 83 Modbus RS485CommissioningPerforming the "Pulsating flow"This Quick Setup menu guides you systematically through the setup procedure for all the devicefunctions that have to be parameterized and configured for measuring pulsating flows. Note that thishas no effect on values configured beforehand, such as measuring range, current range or full scalevalue!XXX.XXX.XXEsc- + EHOME-POSITIONE++Quick Setup+EBQS 1003Plusating FlowDisplaydamping2002Selection totalizerTotalizer 1 Totalizer 2Totalizer 3mQuitTotalizer 3002 Totalizer 3002 Totalizer 3002mode (DAA)mode (DAB)mode (DAC)Yesn Configure another totalizer ?Noo Select output typeCurrent output nFreq.-/Pulse output nQuit4200Operation mode4004Measuring mode4005Time constantFrequency4206Measuring mode4208Time constantPulse4225Measuring modeYesp Configure another output ?No8005Alarm delayAssignLF-Cut offOn-valueLF-Cut offOff-valueLF-Cut off640064026403Pressure 6404shock suppressionQuitQuick SetupFig. 43:Quick Setup for measuring severely pulsating flows.a0004431–en! Note!• The display returns to the cell QUICK SETUP PULSATING FLOW (1003) if you press the Q key combination duringparameter interrogation.• The Setups can be called up either directly after the "COMMISSIONING" Quick Setup or manually by means of theQUICK SETUP PULSATING FLOW (1003) function.mnopOnly totalizers not yet configured in the current Setup are offered for selection in each cycle.The "YES" option remains visible until all the totalizers have been configured. "NO" is the only option displayed when no further totalizers are available.Only the output not yet configured in the current Setup is offered for selection in the second cycle.The "YES" option remains visible until both outputs have been parameterized. "NO" is the only option displayed when no further outputs are available.Issue/Rev. 0.2 (12/12) MN0M030 • Page 63