Proline Promass 83E/F/O Modbus RS485 Operating Instructions

Proline Promass 83 Modbus RS485Commissioning! Note!• The display returns to the cell SETUP COMMISSIONING (1002) if you the press X key combination duringparameter interrogation. The stored parameters remain valid.• The "Commissioning" Quick Setup must be carried out before one of the Quick Setups explained below is run.mnThe "DELIVERY SETTING" option sets every selected unit to the factory setting.The "ACTUAL SETTING" accepts the units you configured beforehand.Only units not yet configured in m the current Setup are offered for selection in each cycle. The unit for mass,volume and corrected volume is derived from the corresponding flow unit.o The "YES" option remains visible until all the units have been configured."NO" is the only option displayed when no further units are available.pThis prompt only appears if a current output and/or pulse/frequency output is available. Only the outputs not yetconfigured in the current Setup are offered for selection in each cycle.q The "YES" option remains visible until all the outputs have been configured."NO" is the only option displayed when no further outputs are available.rThe "automatic parameterization of the display" option contains the following basic settings/factory settingsYESNOMain line = mass flowAdditional line = totalizer 1Information line = operating/system conditionThe existing (selected) settings remain.sThe execution of other Quick Setups is described in the following sections.Issue/Rev. 0.2 (12/12) MN0M030 • Page 61