Proline Promass 83E/F/O Modbus RS485 Operating Instructions

InstallationProline Promass 83 Modbus RS4853 Installation3.1 Incoming acceptance, transport and storage3.1.1 Incoming acceptanceOn receipt of the goods, check the following points:• Check the packaging and the contents for damage.• Check the shipment, make sure nothing is missing and that the scope of supply matches yourorder.#Warning!3.1.2 TransportThe following instructions apply to unpacking and to transporting the device to its final location:• Transport the devices in the containers in which they are delivered.• The covers or caps fitted to the process connections prevent mechanical damage to the sealingfaces and the ingress of foreign matter to the measuring tube during transportation and storage.Consequently, do not remove these covers or caps until immediately before installation.• Do not lift measuring devices of nominal diameters > DN 40 (> 1½") by the transmitter housingor the connection housing in the case of the remote version (å 4). - Use webbing slings slunground the two process connections. Do not use chains, as they could damage the housing.• Promass X, Promass O sensor: see special instructions for transporting ä 13Risk of injury if the measuring device slips. The center of gravity of the assembled measuring devicemight be higher than the points around which the slings are slung.At all times, therefore, make sure that the device does not unexpectedly turn around its axis or slip.Fig. 4:Instructions for transporting sensors with > DN 40 (> 1½")a0004294Page 12 • MN0M030Issue/Rev. 0.2 (12/12)