Proline Promass 83E/F/O Modbus RS485 Operating Instructions

Proline Promass 83 Modbus RS485Troubleshooting"Caution!!Note!9.7 ReturnDo not return a measuring device if you are not absolutely certain that all traces of hazardoussubstances have been removed, e.g. substances which have penetrated crevices or diffused throughplastic.Costs incurred for waste disposal and injury (burns, etc.) due to inadequate cleaning will be chargedto the owner-operator.The following steps must be taken before returning a flow measuring device to ,e.g. for repair or calibration:• Always enclose a duly completed "Declaration of contamination" form. Only then cantransport, examine and repair a returned device.• Enclose special handling instructions if necessary, for example a safety data sheet as perEC REACH Regulation No. 1907/2006.• Remove all residues. Pay special attention to the grooves for seals and crevices which couldcontain residues. This is particularly important if the substance is hazardous to health, e.g.flammable, toxic, caustic, carcinogenic, etc.You will find a preprinted "Declaration of contamination" form at the back of these OperatingInstructions.9.8 DisposalObserve the regulations applicable in your country!9.9 Software historyDate Software version Changes to software Documentation10.2012 3.06.XX – 71197490/14.1209.2011 New Sensor: Promass O and X 71141447/13.1106.2010 Software adjustment 71116480/06.1007.2007 3.04.XX Software adjustment 71036012/12.0612.2006 3.02.XX New Sensor: Promass P and S12.2005 Software extension:– Support t-mass 65 Modbus RS485– (No functional changes forPromass 83 Modbus RS485)71008406/12.0510.2005 3.01.XX Software extension:– Promass I DN80, DN50FB– Additional functionalities for "AdvancedDiagnostics"– Additional functionalities for "Batching"– General device functions11.2004 3.00.XX – 50108189/11.04Issue/Rev. 0.2 (12/12) MN0M030 • Page 107