Atria 6100 Operator's manual - Roxon

GroundingGroundingAll connected equipment must be IEC 60950 approved or equivalent.Consult a qualified technician to verify equipment compatibility.Network SetupThe following communication options require network setup:• Email• Printing to network printers• Sending to EMR via network connection• Sending to shared location on networkNOTE: Press [ALT] + [H] to access the Help menu. SelectNetwork Setup for additional information.Atria Network ConfigurationThe facility network must be set up before connecting the Atria to thenetwork. Use these instructions to configure Ethernet and 802.11networks.1. Press [Home] and then press [Setup].2. Select Send Receive > Setup Network Connection.ETHERNET CONNECTION SETUPTo set up the network using an RJ-45 Ethernet connection1. Select Network Type > Ethernet > Use DHCP:• (Recommended) Select ON for dynamic IP addressassignment.• Select OFF for fixed IP address assignment.2. Enter the following:a. When DHCP is OFF enter:- IP address (IP Address for the Atria, typicallyassigned by the network administrator.)- Subnet Mask (typically 255.255.255.0).- Gateway (IP address for the Gateway.)Atria Electrocardiograph Operating Instructions 5-3