Atria 6100 Operator's manual - Roxon

Using Multiple Electrical ApparatusUsing Multiple Electrical Apparatus!!!WARNINGShock hazard. Connect the Atria only to non-medical equipmentcompliant with IEC 60950 or 60601-1.In addition, the enclosure leakage current of non-medical equipmentconnected to the Atria must not exceed 150µA in fault condition.If necessary, use an additional isolating transformer or floating powersupply to maintain a proper enclosure leakage current and provideadditional protection.WARNINGPatient safety. Non-medical equipment connected to the Atria must not bewithin the patient’s vicinity: 6 feet (1.83 m) beyond the perimeter of thebed, table, or chair, and 7 1/2 feet (2.29 m) above the floor.WARNINGMisdiagnosis. Electromagnetic interference may cause trace noise orinput overload conditions. This may be caused by the presence of strongEMI fields, or generated by RF noise on the line power, or by electronic,surgical, or diathermy instruments in close proximity to the Atria. Positionthe Atria away from other electrical or electronic equipment, if possible.If used with, or around, other electrical or electronic equipment, alwayscarefully monitor initial readings to verify normal operation.The Atria is compliant with IEC 60601-1-2 EMC immunity requirements.Refer to “EMC Declaration Tables” on pg. 11-10.To prevent excessive patient leakage current ensure all patient equipmentmeets certified IEC and ANSI/AAMI medical standards.NOTE: The Atria patient leads are electrically isolatedfrom ground and the device meets IEC and ANSI/AAMImedical standards for leakage current.Password ProtectionThe Atria uses password protection to restrict administrative and directoryaccess. For more information on enabling and setting the password, see“Password Protection” on pg. 4-1.Atria Electrocardiograph Operating Instructions 1-3