Cisco Small Business AP541N Dual-band Single-radio Access Point ...
Cisco Small Business AP541N Dual-band Single-radio Access Point ...
Cisco Small Business AP541N Dual-band Single-radio Access Point ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6Connecting the EquipmentThis section describes the process for connecting the device to powerand the network.STEP 1STEP 2STEP 3Attach the power cord to the power connector and outlet (if used).Connect a network Ethernet cable to the access point Ethernetport.Connect the other end of the Ethernet cable to your network or theEthernet port of the PC you are using to configure the access point.CAUTIONDHCP is enabled by default. If a DHCP server is running onyour network and you have not turned DHCP off, the devicewill accept a new IP address when it is connected to yournetwork. You must use this IP address to configure thedevice.7Verifying the HardwareInstallationTo verify the hardware installation, complete the following tasks:• Check the cable connections.• Check the LED states, as described in the “Getting to Know the<strong>Cisco</strong> AP 541N” section.NOTEIf you need help resolving a problem, visit the <strong>Cisco</strong> <strong>Small</strong><strong>Business</strong> Support Community at www.cisco.com/go/smallbizsupport. For technical documentation and other links, seeWhere to Go From Here, page 14.<strong>Cisco</strong> <strong>AP541N</strong> <strong>Dual</strong>-<strong>band</strong> <strong>Single</strong>-<strong>radio</strong> <strong>Access</strong> <strong>Point</strong> Quick Start Guide 13
Change language