iSR6200 Intelligent Storage Router Installation Guide - QLogic

5–Fibre Channel over IPConfiguring FCIPWindow Scaling (0=Enable, 1=Disable) [Enabled ]Window Scaling Factor (Min=0, Max=9) [7 ]TCP Port No. (Min=1024, Max=65535) [3225 ]GE Port Speed (0=Auto, 1=100Mb, 2=1Gb) [Auto ]Bandwidth, Mbit/sec (Min=1, Max=1000) [1000 ]VLAN (0=Enable, 1=Disable) [Disabled ]FCIP SW Compression (0=Enable, 1=Disable) [Disabled ]All attribute values for FCIP Route 1 will now be saved.NOTE:No action is taken on any of the settings until you complete the last step. Tocancel FCIP route configuration, enter q for any parameter.To configure FCIP in the CLI:1. From a command prompt, enter the fciproute add command.2. Enable (or disable) the FCIP Interfaces FC & GE ports to be used bythe FCIP route.3. At the FC Port prompt, enter the number corresponding to the FC port tobe used for this FCIP route.4. At the GE Port prompt, enter the number corresponding to the GE port tobe used for this FCIP route.5. At the IP Address prompt, enter the router’s GE port IP address (therouter being configured).6. At the Subnet Mask prompt, enter the router’s GE port subnet mask.7. At the Gateway IP Address prompt, enter the router’s GE port gatewayIP address.8. At the Remote IP Address prompt, enter the remote (peer) router’s IPaddress.9. At the MTU Size prompt, specify the maximum transmission unit (MTU),either 0=Normal, 1=Jumbo, or 2=Other.The MTU size is typically set to Normal (1,500 bytes). If all segments ofthe WAN support jumbo frames (9,000 bytes), select Jumbo. The Otheroption is typically used for WANs using encryption that requires the frame tobe less than 1,500 bytes due to encryption overhead.10. At the TCP Window Size prompt, specify the window size for the WAN asdetermined in “TCP Window Settings” on page 5-14.5-4 ISR651101-00 G