iSR6200 Intelligent Storage Router Installation Guide - QLogic

4–ConfigurationControlling per-Host LUN Access on the iSR6200iqn.2004-08.com:isr6200.0834e00019.r1.00.20030020c2075970iqn.2004-08.com:isr6200.0834e00019.r1.00.20030020c2075970iqn.2004-08.com:isr6200.0834e00019.r1.00.20030020c2075970Storage ArrayLog-InLUN 1LUN 3LUN 4LUN 5Host accessible LUNsiSR6200FC1Blade 1FC221:00:00:c0:dd:13:16:f821:01:00:c0:dd:13:16:f821:02:00:c0:dd:13:16:f821:00:00:c0:dd:13:16:f921:01:00:c0:dd:13:16:f921:02:00:c0:dd:13:16:f9Host EntitiesHost Entity 021:00:00:c0:dd:13:16:f821:00:00:c0:dd:13:16:f9Host Entity 121:01:00:c0:dd:13:16:f821:01:00:c0:dd:13:16:f9Host Entity 221:02:00:c0:dd:13:16:f821:02:00:c0:dd:13:16:f9LUN 1LUN 2LUN 3LUN 4LUN 5LUN 6Figure 4-23. Logging In with Mapped LUNsIf you plan to allow all iSCSI hosts unrestricted access to all discovered FibreChannel LUNs, you can completely disable LUN mapping using either SANsurferRouter Manager or CLI commands.The following example shows how to do this using the set system CLIcommand. The red text shows entering the command that enables the LUNmapping.iSR6200 (admin) #> set systemA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.WARNING:If enabled by operator, the Symbolic Name can be embedded as part of theiSCSI Name. Changes to the iSCSI name will be effective after a reboot.Only valid iSCSI name characters will be accepted. Valid characters includealphabetical (a-z, A-Z), numerical (0-9), colon, hyphen, and period.Changes to the Settings below will be effective after a reboot.System Symbolic Name (Max = 64 characters) [Blade-1 ]Embed Symbolic Name (0=Enable,1=Disable) [Disabled ]Target Presentation Mode (0=Auto, 1=Manual) [Auto ]Lun Mapping (0=Enable, 1=Disable) [Disabled ]Controller Lun AutoMap (0=Enable, 1=Disable) [Enabled ]ISR651101-00 G 4-27