iSR6200 Intelligent Storage Router Installation Guide - QLogic

4–ConfigurationEnabling Virtual Port GroupsIf you wish to terminate this wizard before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Configuring VpGroup: 1-------------------------Status (0=Enable, 1=Disable) [Enabled ]VpGroup Name (Max = 64 characters) [VPGROUP_1 ]All attribute values for VpGroup 1 that have been changed will now be saved.Configuring VpGroup: 2-------------------------Status (0=Enable, 1=Disable) [Disabled ] 0VpGroup Name (Max = 64 characters) [VPGROUP_2 ]All attribute values for VpGroup 2 that have been changed will now be saved.Configuring VpGroup: 3-------------------------Status (0=Enable, 1=Disable) [Disabled ] 0VpGroup Name (Max = 64 characters) [VPGROUP_3 ]All attribute values for VpGroup 3 that have been changed will now be saved.Configuring VpGroup: 4-------------------------Status (0=Enable, 1=Disable) [Disabled ]All attribute values for VpGroup 4 that have been changed will now be saved.The following example shows CLI command output using an iSR6200 blade withthree virtual port groups enabled. You can view information about the virtual portgroups configured on your iSR6200 by issuing the show vpgroups command.iSR6200 (admin) #> show vpgroupsVpGroup Information---------------------Index 1VpGroup NameVPGROUP_1StatusEnabledWWPNs21:00:00:c0:dd:13:16:f821:00:00:c0:dd:13:16:f9ISR651101-00 G 4-5