iSR6200 Intelligent Storage Router Installation Guide - QLogic

3–InstallationInstalling New Firmware3. At the ftp prompt, type bin to set binary mode. For example:ftp> bin200 Type set to I.4. Use the put command to transfer the firmware image file from theworkstation to the router. For example:ftp> put isr-6200-3_0_0_5.bin200 PORT command successful.150 Opening BINARY mode data connection for'isr-6200-3_0_0_5.bin'.226 Transfer complete.ftp: 4822816 bytes sent in 0.41Seconds 11878.86Kbytes/sec.5. Enter quit.The firmware image has been transferred to the router.6. At a Telnet prompt, log on to the router as an administrator.7. Select one of the blades.8. Enter the following command from the router, where x indicates thefirmware image name:image unpack isr-62xx-x_x_x_x.binThe following message appears:Unpack Completed. Please reboot the system for FW to takeeffect.9. Enter reboot.The following message appears:Are you sure you want to reboot the System (y/n):10. To reboot the system, type y.11. If a second blade is installed, repeat this procedure.ISR651101-00 G 3-17