iSR6200 Intelligent Storage Router Installation Guide - QLogic

3–InstallationInstalling New Firmware2. Open an admin session, select a blade (1 or 2), and then enter thecommands to set up both iSCSI ports and the management interface. (Seethe iSR6200 CLI User’s Guide for command descriptions.)iSR6200 #> admin startPassword : ******iSR6200 (admin) #> set mgmt………………………iSR6200 (admin) #> set iscsi 1………………………iSR6200 (admin) #> set iscsi 2………………………Connecting Cable Devices to the RouterConnect cables to the SFP transceivers and their corresponding devices. Devicescan have SFP (or small form factor, SFF) transceivers or GBICs. Choose the fiberoptic cable with the connector combination that matches the device beingconnected to the router:• LC-type duplex fiber optic cable connectors are designed for SFPtransceivers.• SC-type connectors are designed for GBICs.• OM-3 connectors are designed for 10Gb ports.Installing New FirmwareThe router comes with the current firmware installed. You can upgrade thefirmware from the management workstation when new firmware becomesavailable.To locate and download new firmware:1. Go to the QLogic Downloads and Documentation page located here:http://driverdownloads.qlogic.com2. Under QLogic Products, type router firmware in the search box.(Alternatively, you can click the Guided Search link to obtain assistance inlocating the firmware to download.)3. In the results box under Resource Name, click the router firmware that youwant to install, and then download the file.You can use either SANsurfer Router Manager or the CLI to install new firmware,as shown in the following sections.ISR651101-00 G 3-15