iSR6200 Intelligent Storage Router Installation Guide - QLogic

3–InstallationInstalling the iSR6200 RouterStarting SANsurfer Router ManagerTo start SANsurfer Router Manager, use the applicable method:• For Windows, either double-click the SANsurfer Router Manager desktopshortcut, or click Start, point to All Programs, point to QLogicManagement Suite, and then click SANsurfer Router Manager, dependingon how you installed the SANsurfer Router Manager utility.• From a Windows command line, issue the following command:SANsurferRouterManager.exe• From a Linux command prompt, issue the following command:./SANsurferRouterManagerConfiguring the RouterYou can configure the router using either SANsurfer Router Manager or the CLI.In SANsurfer Router Manager, configure router ports by selecting a Fibre Channelor iSCSI port in the left pane (tree pane), and then completing the Information andAdvanced Configuration pages for that port in the right pane. For details, see theiSR6200 Router Manager User’s Guide, “FC Ports” and “iSCSI Ports” sections.To configure the router using the command line interface:1. Open a command window according to the type of workstation andconnection:Ethernet (all platforms): Open a Telnet session with the default routerIP address and log into the router with the default account name(guest) and password (password):telnet 10.0.0.1username: guestpassword: ********Serial, Windows: Open the HyperTerminal application on a Windowsplatform as follows:a. From the Windows Start menu, click Programs, point toAccessories, point to Communications, and then clickHyperTerminal.b. Select the connection you created earlier, and then click OK.Serial, Linux: Open a command window and enter the followingcommand:minicom3-14 ISR651101-00 G