iSR6200 Intelligent Storage Router Installation Guide - QLogic

3–InstallationInstalling the iSR6200 RouterTo power on the router:1. Attach the AC power cord to the power connector, located on the back sideof the PCM connected directly behind the router blade.2. Connect the opposite end of the power cord to a grounded AC wall outlet orpower strip.3. Check the PCM power LED to make sure the fan is operational (green = OK,yellow = no AC power).Figure 3-2 shows the location of the ports and LEDs on one of the bladescontained within the iSR6200 unit that are referenced in the followinginstructions.RS232 Port Heartbeat LED Power LEDExpansion Ports Based on ModeliSR6200 SystemGE4 GE3 iSR624010GbE210GbE1 iSR6250Intelligent Storage RouterIntelligent Storage RouterMGMT IOIOI FC1 FC2 GE1 GE1Management PortSystem Fault LEDFibre Channel PortsFigure 3-2. iSR6200 Blade Ports and LEDsiSCSI Ports4. Verify that the router’s input power LED is illuminated.The iSR6200 router runs its self test and begins normal operation—this maytake a minute.5. Verify that the heartbeat LED is blinking (once per second) and that thesystem fault LED is not illuminated.If an error has occurred, the system fault LED blinks a pattern that indicates thefault reason. For more information about error blink patterns, see page 6-2.Connecting the Management Workstation to the RouterYou can manage the router using either SANsurfer Router Manager or the CLI.SANsurfer Router Manager requires an Ethernet connection to the router. The CLIcan use either an Ethernet connection or a serial connection. Choose the routermanagement method, and then connect the management workstation to therouter in one of the following ways:• Indirect Ethernet connection from the management workstation to therouter RJ45 connector through an Ethernet switch or hub. This requires a 10or 100 Base-T straight cable.3-8 ISR651101-00 G