iSR6200 Intelligent Storage Router Installation Guide - QLogic

3–InstallationInstalling the iSR6200 RouterConnecting the Router to AC PowerWARNING!!This product is supplied with a three-wire power cable and plug for theuser’s safety. Use this power cable in conjunction with a properly groundedoutlet to avoid electrical shock. An electrical outlet that is not correctly wiredcould place hazardous voltage on metal parts of the router chassis. Thecustomer must make sure the outlet is correctly wired and grounded toprevent electrical shock.You may require a different power cable in some countries because the plugon the cable supplied with the equipment will not fit your electrical outlet. Inthis case, you must supply your own power cable. The cable must meet thefollowing requirements:• For 125 volt electrical service: the cable must be rated at 10 amperesand be approved by UL and CSA.• For 250 volt electrical service: the cable must be rated at 10 amperes,meet requirements of H05VV-F, and be approved by VDE, SEMKO, andDEMKO.Figure 3-1 shows the front and back plates of an iSR6200 router chassis thatcontains two router blades with add-in ports installed for its model. Each PCMprovides a power connector, as well as a Status LED.Front Plate iSR6200 Blade 1 Front Plate iSR6200 Blade 2Expansion SlotExpansion Slot10GbE1 iSR625010GbE2 10GbE1 iSR6250Inte ligent Storage Router10GbE2Inte ligent Storage RouterFC1FC2FC1FC2MGMTIOIOIMGMTIOIOIPCM Status LEDPower ConnectorPCM Status LEDPower ConnectorBack Plate PCM for Blade 2 Back Plate PCM for Blade 1Figure 3-1. iSR6200 Router Chassis—Front and Back PlatesRefer to Figure 3-1 to locate the power connector and PCM status LED for theblade you are configuring.ISR651101-00 G 3-7