iSR6200 Intelligent Storage Router Installation Guide - QLogic

1–IntroductioniSR6200 Router BladesReset a Router BladeThe maintenance button is a multifunction momentary switch on the front panel. Ithas the following functions:• “Reset a Router Blade” on page 1-9• “Reset and Select Boot Image” on page 1-9• “Reset IP Address” on page 1-9• “Enable DHCP” on page 1-10• “Restore Factory Defaults” on page 1-10To reset the router blade, use a pointed, nonmetallic tool to momentarily press andrelease (less than two seconds) the maintenance button. The router responds asfollows:1. All the router blade LEDs light up.2. After about two seconds, the POST begins, turning off the heartbeat andsystem fault LEDs.3. When the POST is complete, the power LED is on and the heartbeat LEDflashes once per second.Reset and Select Boot ImageYou can reset the router using either the primary or secondary boot image:• Primary Image—To reset the router and select the primary boot image, usea pointed, nonmetallic tool to press and hold the maintenance button untilthe heartbeat LED flashes once, and then release the button. The routerboots from the primary boot image. The boot time is less than one minute.• Secondary Image—To reset the router and select the secondary bootimage, use a pointed, nonmetallic tool to press and hold the maintenancebutton until the heartbeat LED flashes twice, and then release the button.The heartbeat LED flashes twice. The router boots from secondary bootimage. The boot time is less than one minute.Reset IP AddressTo reset the router and restore the maintenance port IP address to the default(10.0.0.1), use a pointed, nonmetallic tool to press and hold the maintenancebutton until the heartbeat LED flashes six times, and then release the button. Therouter boots and sets the maintenance port to IP address 10.0.0.1. The boot timeis less than one minute.The IP address set by this method is not persistent; to make the changepersistent, use the CLI or SANsurfer Router Manager to set the IP address. Formore information, see the iSR6200 Router Manager User’s Guide and theiSR6200 CLI User’s Guide.ISR651101-00 G 1-9