iSR6200 Intelligent Storage Router Installation Guide - QLogic

1–IntroductioniSR6200 Router BladesTable 1-3. System Fault LED Blink PatternsSystemFault LEDConditionOFFOK (operational)Input Power LED (Green)The power LED shows the voltage status of the router logic circuit board. Duringnormal operation, this LED lights up to show that the router logic circuit board isreceiving the DC voltage from the power supply.Beacon Indicator (Blue)The iSR6200 router blade’s printed circuit board (PCB) has a blue beacon lightinstalled near the center vent hole between the Fibre Channel ports (Figure 1-8).This light enables you to locate the physical blade when monitoring the iSR6200routers using SANsurfer Router Manager. If you enable the Beacon On option fora selected blade in SANsurfer Router Manager, the blue beacon light flashesthrough the vent hole on the chassis blade’s faceplate.Maintenance Button1 Blink Beacon; synchronized with the heartbeat LED3 Blinks System error4 Blinks Management port IP address conflict5 Blinks Over-temperatureThe maintenance button shown in Figure 1-9 is the only router blade control.Press this button to reset the router blade or to recover it if it becomes disabled.iSR6200 SystemGE4 GE3 iSR624010GbE210GbE1 iSR6250Intelligent Storage RouterIntelligent Storage RouterMGMT IOIOI FC1 FC2 GE1 GE1Figure 1-9. Router Blade ControlsMaintenance Button1-8 ISR651101-00 G