iSR6200 Intelligent Storage Router Installation Guide - QLogic

C–Log MessagesTable C-1. iSR6200 Router Log Messages (Continued)IDLog MessageModuleTypeMsg.TypeDescription107078 #%d: QLUpdatePort 0x%x: out of slots inhost database107984 #%d: QLWriteFlashDword: Write fails ataddr 0x%x data 0x%x108032 #%d: QLGetVpDatabase:MBOX_CMD_GET_VP_DATABASE for VP %d fatalerror108033 #%d: QLGetVpDatabase:MBOX_CMD_GET_VP_DATABASE for VP %d failed%x108049 #%d: QLVerifyMenloFw:EXECUTE_COMMAND_IOCB failed MB0 %x MB1 %x108050 #%d: QLVerifyMenloFw:EXECUTE_COMMAND_IOCB fatal error108064 #%d: QLGetFwState: Get Firmware Statefailed 0-3 %x %x %x %xFC Error The driver was unable to re-establish connection tothe target within the timeout and retry counts, and istherefore marking it offline.FC Error The Fibre Channel controller failed a Flash write(address x data x).FC Error The Fibre Channel controller failed the Get VP Databasecommand (for virtual port %d).FC Error The Fibre Channel controller failed the Get VP Databasecommand (for virtual port %d) with status x.FC Error The Fibre Channel controller reported failure statusfor an Execute IOCB (input/output control block)command.FC Error The Fibre Channel controller reported a fatal errorwhile processing an Execute IOCB command.FC Error The Fibre Channel controller reported failure statusfor a Get Firmware State command.118882 #%d: QLIoctlDisable: Reset adapter FC Info Request to reset the Fibre Channel processor(adapter) received from IOCTL interface.119088 #%d: QLIsrEventHandler: LIP occurred(%x): mailbox1 = %xFC Info Fibre Channel loop initialization process (LIP)occurred. The LIP type is reported, as is the contentsof the Fibre Channel processor’s mailbox 1 register.ISR651101-00 G C-21