iSR6200 Intelligent Storage Router Installation Guide - QLogic

B–Simple Network Management ProtocolSNMP Trap ConfigurationSNMP Trap ConfigurationSNMP trap configuration lets you set up to eight trap destinations. Choose fromTraps 1–Trap 8 to configure each trap. Table B-2 describes the parameters forconfiguring an SNMP trap.Table B-2. SNMP Trap Configuration ParametersParameterTrap nenabledTrap address *Trap port*DescriptionEnables or disables trap n. If disabled, the trap is not configured.Specifies the IP address to which the SNMP traps are sent. A maximum of eighttrap addresses are supported. The default address for traps is 0.0.0.0.Port number on which the trap is sent. The default is 162. If the trap destinationis not enabled, this value is 0 (zero). Most SNMP managers and managementsoftware listen on this port for SNMP traps.Trap versionSpecifies the SNMP version (1 or 2) with which to format traps.Table Note* Trap address (other than 0.0.0.0.) and trap port combinations must be unique. For example, if trap 1 and trap2 have the same address, they must have different port values. Similarly, if trap 1 and trap 2 have the same portvalue, they must have different addresses.ISR651101-00 G B-3