iSR6200 Intelligent Storage Router Installation Guide - QLogic

B–Simple Network Management ProtocolSNMP ParametersSNMP ParametersYou can set the SNMP properties using SANsurfer Router Manager or the CLI.For SNMP configuration details, see the iSR6200 Router Manager User’s Guideor the iSR6200 CLI User’s Guide.Table B-1 describes the SNMP parameters.Table B-1. SNMP ParametersParameterRead communityTrap communitySystemlocationSystem contactAuthenticationtrapsDescriptionA password that authorizes an SNMP management server to read informationfrom the router. This is a write-only field. The value on the router and the SNMPmanagement server must be the same. The read community password can beup to 32 characters, excluding the number sign (#), semicolon (;), and comma(,). The default is password is private.A password that authorizes an SNMP management server to receive traps.This is a write-only field. The value on the router and the SNMP managementserver must be the same. The trap community password can be up to 32 characters,excluding the number sign (#), semicolon (;), and comma (,). The defaultpassword is private.Specifies the name of the router location. The name can be up to 64 characters,excluding the number sign (#), semicolon (;), and comma (,). The default isundefined.Specifies the name of the person to be contacted to respond to trap events. Thename can be up to 64 characters, excluding the number sign (#), semicolon (;),and comma (,). The default is undefined.Enables or disables the generation of authentication traps in response toauthentication failures. The default is disabled.B-2 ISR651101-00 G