iSR6200 Intelligent Storage Router Installation Guide - QLogic

7–Removal and ReplacementiSR6200 Chassis Blades150 Here comes the directory listing.iSR6200_FRU.bin226 Directory send OK.ftp: 17 bytes received in 0.00Seconds 17000.00Kbytes/sec.ftp> get iSR6200_FRU.bin200 PORT command successful. Consider using PASV.150 Opening BINARY mode data connection for iSR6200_FRU.bin (20010 bytes).226 File send OK.ftp: 20010 bytes received in 0.00Seconds 20010000.00Kbytes/sec.ftp> bye221 Goodbye.4. Disconnect all cables from the iSR6200 blade. This includes all FibreChannel, Ethernet, and serial cables. You can leave the power cablesconnected. (See Figure 7-5.)NOTE:After you have installed the new blade, you must access it. Use acomputer with a TCP/IP interface capable of using Telnet to connect tothe new blades default IP address of 10.0.0.1. Make sure you havesuch a computer available before you remove your old blade, and thatthe computer has the FRU file on it you saved in step 3.Figure 7-5. iSR6200 Router Blade with Cables Disconnected5. Remove the old blade from the chassis. Figure 7-6 shows how to releasethe latch and pull down on the lever on the right side (1), and then pullstraight back on the handle (2).7-6 ISR651101-00 G